Cuff Ring:

Find the right size Cuff Ring. Open the cuff ring and put it behind the ball sack. Find the smallest size possible for a comfortable, secure fit. Close the ring and insert the locking pin in the middle hole. (If you experience any swelling or discoloration in the ball sack while wearing ‘The Curve’ go to the next larger size).

Cage Portion:

Lubricate the head and top shaft of the penis with baby oil or baby gel. Insert the penis into the cage. Push the penis down in order to avoid pinching when inserting the guide pins for connection to the Cuff Ring.

Spacers:

Spacers are provided for proper fitting. Spacers go between the Cage Portion and Cuff Rings on the locking pin. This insures security and comfort and avoids any pinching. The small spacer goes behind the lock and in front of the cage portion when needed.

Guide Pins:

The two guide pins will be inserted into the Cuff Ring. Once you wear it for a few days and find the proper spacing, cut the ends of the guide pins off with a pair of side cutter pliers and smooth the edges with an emery board.

Locks:

Attach the brass lock through the hole at the end of the locking pin. Plastic locks are provided for passing thru metal detectors.

Cleaning:

Use a mild soap and soft type brush. “Do Not” use household cleaning products.

Note: After showering, apply baby oil or baby gel to the head of the penis and spread with a cotton swab. This allows the penis to easily slide back down into the cage portion.

CB-2000

Lubricate the head and top shaft of penis with gel or lotion.

Ring-A: Pull a little skin from the ball sack through the ring. Push one of the testicles through the ring. Take a little more skin and push the other testicle through. Push the penis down through the ring.

Locking Pin: Insert the locking pin from behind the A-Ring. Make sure you insert it through the recessed side.

Ring-B: Feed the penis through Ring-B. Push the penis down in order to avoid pinching when inserting guide pins for connection of Ring-A and Ring-B.

Spacers: Spacers are provided for proper fitting. Spacers go between Ring-A and Ring-B on the locking pin. This insures security and comfort and avoids pinching. The small spacer goes behind the lock and in front of Ring-B.

Guide Pins: Connect Ring-A and Ring-B by way of the guide pins. After finding the proper spacing you may need to cut down the guide pins. If necessary, simply use a pair of side cutter pliers and then smooth the edges with an emery board.

Locks: Attach the brass lock through the hole at the end of the locking pin. Plastic locks are provided to pass through metal detectors.

Cleaning: Use a mild soap and soft type brush (toothbrush). Do Not Use Household Cleaning Products.

NOTE: After showering, apply lotion to head of penis and spread with cotton swab. This allows the penis to easily slide back down into the cage portion

Points of Intrigue: The long edge goes towards the ‘B’ Ring. Insert the locking pin through the ‘A’ Ring,

Spacer(s) and then through the ‘B’ Ring.